Wipe all stains with a damp sponge. If any stain remains, apply Soft Scrub with a damp sponge, work in a circular motion and rinse. If stain persists saturate a cotton ball with alcohol and blot the stain and rinse.

FOR STAINLESS STEEL APPLIANCES - Use any stainless steel cleaning product per the manufacturer’s direction. Repeat as needed

Scrape off any excess Glitter Dots. Mix liquid dish soap with water, use a sponge or paper towels to wipe the stained area. Repeat as needed.

To make the paint easier to remove, wet the paint and wait five (5) minutes.  Spray area with the highest setting on a garden hose nozzle, as close to the paint as possible and at a slight angle.  If any stain remains, wet the area and brush with a stiff bristle nylon brush or broom.  Rinse away completely to prevent paint from redepositing on the surface.

Wet Paint:

1. Using paper towels, wipe up as much paint as possible.

2. Make a mixture of dish soap and warm water. Using a sponge or cloth, apply the soapy water to the area and use a circular motion. Continue scrubbing and rinsing the cloth or sponge until no more colorant can be removed.

3. If the stain remains, spray a mild degreaser, such as Formula 409, on the affected area. Let it sit for a few minutes, then wipe the area with a wet soapy cloth or sponge and repeat, as needed.

Dry Paint:

1. Saturate the remaining paint with a solution of warm water and dish soap.

2. Use a sponge or cloth, and rub the area in a circular motion to help lift the paint. The warm, soapy water will help life the paint.

3. If the stain remains, spray a mild degreaser, such as Formula 409, on the affected area. Let it sit for a few minutes, then wipe the area with a wet soapy cloth or sponge and repeat, as needed.

Wipe all stains with a damp sponge. If any stain remains, apply Soft Scrub with a damp sponge, work in a circular motion and rinse. If stain persists saturate a cotton ball with alcohol and blot the stain and rinse.

FOR STAINLESS STEEL APPLIANCES - Use any stainless steel cleaning product per the manufacturer’s direction. Repeat as needed